Sudo /bin/su -c "echo -e '\n#Enable IP Routing\_forward = 1' > /etc/nf" I've added ip forwarding and masquerade rules to the Pi so that other devices at the remote site can use it as their gateway: So this part of the setup is working properly. The host network can access the Pi via it's VPN ip address of 10.242.2.3. I have the Pi at the remote site, OpenVPN is installed, openvpn config files for the remote user are in place, connection is established and the Pi can access things on the host network (192.168.2.0/24) without issue. Again, I've used the Sophos Red devices, hoping to save money using Pis. We now have entire remote sites that need to connect via VPN and I'm hoping that a Raspberry PI client acting as a VPN gateway can accomplish this. Laptops and cell phones can connect and have access to resources at the host network (192.168.2.0/24) without issue. We have SSL Remote Access configured in our Sophos UTM. Especially when you need to tie in 30 remote sites. If you want to support me, buy stuff over my Amazon links or click on an advertisement.Before I start I want to say that I have a remote site up and running using a Sophos Red device - but $300 vs. Registration, Software Download and Installation Sophos UTMįeel free to comment the recommendation or ask for further installation help. ![]() ![]() These are my server components: CPUĢx be Quiet Pure Wings 2 (case back and for the hdd’s) If you need inspiration for a home server. You can use it for guest wifi or whatever you want. You can use vlan interfaces for eth0 without any setup by the hypervisor. On my UTM for LAN eth0 (virtio) and for WAN eth1(PCI Passtrough realtec NIC).Ī nice feature. If it was the wrong interface, restart the installation process and select the other NIC in the list for the LAN.Īfter the installation, you have 2 hardware NICs in the UTM. The LAN-NIC should be the first interface. When installing the UTM, you must select a LAN NIC. insert the “WAN NIC” via PCI Passthroughīe sure if it is the right PCIe slot and NIC.I recommend virtio for NIC device model, because according to my own experience it offers the best data throughput. activate the bridge mode for the “LAN NIC”.activate auto start while booting of the hypervisor.We have been busy and now have a fully installed Ubuntu and Virt Manager and are starting to configure the virtual UTM. With PCI Passthrough, all traffic goes directly to the virtual firewall and cannot escape from a virtual switch and has no logical contact with the hypervisor (the Ubuntu server). Why do I use PCI Passthrough? It is safer. you need a pcie slot for the NIC where the PCIe lanes are not shared with the chipset or other components.and the last NIC via PCI Passthrough exclusive for the UTM WAN interface (you can’t use a dual NIC for this).the second NIC in bridge mode for the VMs.I use the Mainboard NIC for the Server management. ![]() A Ubuntu System (with a GUI, it’s easier ) ). ![]() The following link deals with the basic configuration of virt manager under ubuntu: In this article I assume that Ubuntu and virt manager are installed. Today I will tell you how I configured my home server for a virtual Sophos UTM.Īll configurations in ubuntu can also be used for a virtual Sophos XG.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |